Anyone help with an Itelite DBS nanosync antenna question?

[Texas Mavic]

I have installed a set of sma connectors on the Mavic Pro, so I can swap out antennas. I am waiting patiently on it arriving, however it was brought to my attention that I might not have enough length in my current connectors to accommodate the bracket, a nut, and the jumper. Anyone out there that can clarify if I need to take the RC apart again or if what I have will work, I would be sincerely appreciative!!
Is this enough room for the itelite Nanosync bracket, and washer? Or will I need to install the sma pigtails that come with the antenna to accommodate the bracket?
Just trying to fabricate ahead of the curve!! Weather in Houston has been terrible and I am anxious to fly these mods!!

 

[Jeffm912]

It looks fine, as the bracket almost sits flush with the controller case when installed.

Jeff