Completed My Skins and Decals

[howardK]

I got my second wrap in for my M1P. It is made by a company called Wrapgrade. i got it on Amazon. I also ordered the set for the controller as well as extra batteries. i have attached photos. I did the controller first, then the batteries and the drone body and finally the arms. The Final photo shows both of my M1p's all dressed up

 

[suade8880]

I got my second wrap in for my M1P. It is made by a company called Wrapgrade. i got it on Amazon. I also ordered the set for the controller as well as extra batteries. i have attached photos. I did the controller first, then the batteries and the drone body and finally the arms. The Final photo shows both of my M1p's all dressed up

Nice bright colors. A way to increase VLOS right away. Wrapgrade has a very nice and precise fit.

 

[Gonzo66]

The orange looks great. How do you like the Master Airscrew propellers?

 

[naiku]

Here's my M2P and my son's Mini. Wraps came from decalgirl. Frustratingly the wrap on the M2P is coming off in places, I'm not sure why, I had a skin from them on my Mavic Air that never peeled, the Mini isn't peeling, just the M2P. Yes, the drone was cleaned prior to applying the skin.

 

[suade8880]

Here's my M2P and my son's Mini. Wraps came from decalgirl. Frustratingly the wrap on the M2P is coming off in places, I'm not sure why, I had a skin from them on my Mavic Air that never peeled, the Mini isn't peeling, just the M2P. Yes, the drone was cleaned prior to applying the skin.

Nice dynamic duo you got there! Have you tried using a little heat(hair dryer)to the skins to see if sticks better. After a wrap I always go over it with a little heat to activate the adhesive up.

 

[Bob1956]

Has anyone experienced any issues with these full wraps? Transmission strength and overheating come to mind.

 

[naiku]

Have you tried using a little heat(hair dryer)to the skins to see if sticks better. After a wrap I always go over it with a little heat to activate the adhesive up.

Might be worth a try, although it might also be too late with this particular wrap, still good to know for future. Honestly, I am not sure why this one does not seem to stick as well as the other 2 I have purchased from Decal Girl. Literally zero issues with the skin on my Mavic Air or on the Mini pictured, yet for some reason the one on the M2P refuses to stay stuck especially on the legs/arms.

 

[suade8880]

Has anyone experienced any issues with these full wraps? Transmission strength and overheating come to mind.

I haven’t heard any issues nor encountering any. The wraps are so thin that it wouldn’t do anything to deter the transmission strength. I left the aluminum bottom plate bare as it does get pretty warm perhaps it acts as a heat sink so I left it alone.

 

[howardK]

i dont think i am as technical as most of you but i like the way my M1P's perform. I just got green blades for the green one