connection Issues

[tck444]

After the drone ( Mavic Air 1 ) connects, then I see "Connection Successful". Press "Done". Then goes right back to the connection page. May do this 10 times before actually seeing the "Go Fly" message ?

When I finally get into fly mode, then I receive "Error 200" message.

I believe I have all the latest firmware.

Suggestions welcome

 

[Marty Markoe]

Basics 1st.

1. Run Compass and IMU calibration.
2. Start up from different area as there's chance of magnetic interference.
3. Reinstall DJI GO on controller.
4. Update or if already updated reinstall firmware.

 

[tck444]

Perhaps magic or coincidence, when I changed the (perhaps defective) Micro SD card the problem seemed to disappear ?????