DJI RC firmware update to V01.03.0400

[Rockowe]

The previous version of the fcc.exe 1 month back was working and had been used. My version on RC was 0200.
Then the automatic update upgraded the RC to 0500.
I lost the FCC on the controller.
So I ran the Old RcFcc.exe again... and it gave the message of could only work 0400 and below.

I asked the guy I bought the hack from....
He said he couldn't help. It was too late after straight upgrade to 0500.

I asked for the latest version of rcfcc.exe.
He did send the link of June fcchack.7z
But when I used it it gave a different msg that said it could only work (hack) on 0100.

I downgraded. RC to 0400.
..
But the new fcc.exe still did not work.
BTW the version of the rcfcc.exe was dated 230515

So that's where I am now still no FCC after $69 ...

 

[cornz]

I'vr been speaking to FCC MOD, here is the latest transcript:



BEGIN:
Hi Max. Any news on the new DJI firmware and getting FCC mode on it?
VISIT THIS LINK DJI RC / RC Pro FCC - Updates

Ok Max, so just for clarity. IF i have firmware 01.03.0100 then IF i run the "hack" again, i can then update to 1.03.0500 and then the FCC Mod will still work or will i have to run the hack again AFTER upgrading to 01.03.0500
need hack again on 500

Ok, So,HACK, then UPGRADE to 01.03.0500 then HACK and FCC will work??


if hack Reinstalled on 100, then yes

you can update to 500 and hack RC again

if you update WITHOUT reinstall, hack not available

END:::

SO as long as you have a lower version than xxxx030 then you run the hack, upgrade to xxxx0500, run the hack again and FCC mode is enabled. But IF you have xxxx.0400 then you're screwed for the moment. ALso, it is only the DJI RCI controller, not the PRO or the basic mobile phone variant.

 

[aytacengin]

DJI RC 2 (Air 3, Mini 4 pro) is supported now!

 

[GravityRZ]

as far as i can tell the new version can now install the fcc hack even when you are on a higher fw version and did not install the fcc hack before

i think halvway the proces it downloads a hacked firmware 0400 which you need to copy manually to the right place

 

[hgserv]

Any news on this????
All the methods are useless right now