Does anybody know how to fly above altitude restriction when flying indoors? I needed to take a closeup look at some light fixtures by a 25’ ceiling but couldn’t go past 15’. I disabled by basin sensors but it still wouldn’t let me go any higher.
- Joined
- Oct 12, 2016
- Messages
- 30,019
- Reactions
- 33,825
- Location
- Harrisburg, PA (US)
- Site
- mavichelp.com
- Joined
- Oct 12, 2016
- Messages
- 30,019
- Reactions
- 33,825
- Location
- Harrisburg, PA (US)
- Site
- mavichelp.com
Mavic 2 Atti mode
I haven't seen anyone else mention it so, just in case anyone is interested, I can confirm that it is possible to switch the M2P into ATTI mode by changing the mapping on the flight mode switch using the same DJI Assistant functionality as with the MP. I altered the Sport mode setting (8) to...
mavicpilots.com
Ok thanks I’ll check it out. I did disable vision sensors but for some reason it still sensed the ceiling.
- Joined
- Oct 12, 2016
- Messages
- 30,019
- Reactions
- 33,825
- Location
- Harrisburg, PA (US)
- Site
- mavichelp.com
Did you disable Vision Positioning? That's the setting that causes this restriction.
BD0G
Well-Known Member
no need to be too careful - just be aware that drone drifts freely in the atti, so you need to keep an eye contact 100% and be VERY gentle with throttle.
as many stated before - it is a good idea to get prop guards and put them on when you fly indoors, no matter the size of indoors.
obviously, practice it outside first before turning it on in the house.
- Joined
- Oct 12, 2016
- Messages
- 30,019
- Reactions
- 33,825
- Location
- Harrisburg, PA (US)
- Site
- mavichelp.com
Page 57 of your manual explains what you need.
Height is restricted to 16 ft (5 m) when the GPS signal is weak and Downward Vision System is activated.
Height is restricted to 98 ft (30 m) when the GPS signal is weak and Downward Vision System is inactivated
Similar threads
