Hi guys,
Sorry if this has been talked about before. I crashed my drone mavic Air and saw the video transmission cable was broken. Got a new on and video is working fine.
My issue is that the gimbal now only moves slightly up and down when turning the Mavic on. I have done an auto calibration which it passed but again the camera doesn’t do a full range of movement up and down. I can move the gimbal the same distance up and down when using the remote but not the full range... the camera seems to heat up a lot as well.
The gimbal has no tightness when moving it while the drone is off. I’m also getting the gimbal overload.
I haven’t seen or heard anyone with this issue. I’m not sure if that would be a flat ribbon cable issue or a gimbal motor issue?
Any ideas on a fix??
Sorry if this has been talked about before. I crashed my drone mavic Air and saw the video transmission cable was broken. Got a new on and video is working fine.
My issue is that the gimbal now only moves slightly up and down when turning the Mavic on. I have done an auto calibration which it passed but again the camera doesn’t do a full range of movement up and down. I can move the gimbal the same distance up and down when using the remote but not the full range... the camera seems to heat up a lot as well.
The gimbal has no tightness when moving it while the drone is off. I’m also getting the gimbal overload.
I haven’t seen or heard anyone with this issue. I’m not sure if that would be a flat ribbon cable issue or a gimbal motor issue?
Any ideas on a fix??