I’ll start by saying I’ve used the search feature extensively as well as on the DJi forum, but haven’t found any solution and most posts seem to be 4-6 months old.
Finally got my new Apline white MP out for a good fly this evening to stretch its legs, I have about 25 min in flight time on the unit.
Gimbal vibrates, and decides to do its own thing for a few seconds. Video link attached.
-Hasn’t been in a crash, MP firmware is V.01.04.0300
-DJIGo app firmware is V4.2.14(3118)
-No mods
-No error code
-Gimbal brackets all where they suppose to be
-Ruled out SD card, happened with original & my 64gb card out of my GoPro
-Was thinking wind, but at the time shown in the video I was low & slow and there was barely a breeze
-It was chilly, I’ve read that could be a cause. Lame if it is though
I’m not down and out yet, because at the time my Vision Sensors where not calibrated, and the MP firmware version stated above was only updated once I got home and downloaded DJI assistant and updated via USB cord then was able to calibrate Vision sensors, I’ve also recalibrated the gimbal. Hovered around the house and so far so good, be tomorrow evening or the next before I can attempt outside normal flight again.
Basically I just want to know if this has be sorted? Besides sending off for replacement.
Regards.
Finally got my new Apline white MP out for a good fly this evening to stretch its legs, I have about 25 min in flight time on the unit.
Gimbal vibrates, and decides to do its own thing for a few seconds. Video link attached.
-Hasn’t been in a crash, MP firmware is V.01.04.0300
-DJIGo app firmware is V4.2.14(3118)
-No mods
-No error code
-Gimbal brackets all where they suppose to be
-Ruled out SD card, happened with original & my 64gb card out of my GoPro
-Was thinking wind, but at the time shown in the video I was low & slow and there was barely a breeze
-It was chilly, I’ve read that could be a cause. Lame if it is though
I’m not down and out yet, because at the time my Vision Sensors where not calibrated, and the MP firmware version stated above was only updated once I got home and downloaded DJI assistant and updated via USB cord then was able to calibrate Vision sensors, I’ve also recalibrated the gimbal. Hovered around the house and so far so good, be tomorrow evening or the next before I can attempt outside normal flight again.
Basically I just want to know if this has be sorted? Besides sending off for replacement.
Regards.
Last edited:
