- Joined
- Oct 18, 2018
- Messages
- 37
- Reactions
- 5
- Age
- 24
Hi Guys
Today I has fly my bird in some canyons and it loose first GPS and after this the connection to the controller. RTH doesn't work without GPS, so the Mavic hover and then after one minute it descend and try to land. I was lucky, the terrain war very rough and the drone stay in the air few centimeters above ground. After about 3 minutes, the GPS comes back but still no connection to the controller. RTH still doesn't work because the drone was in landing mode. After about 8 minutes I found a place to reconnect the drone, cancel the landing question "yes/no" and fly back home.
Is there any possibility by using the debug mode to change this behavior? I would like, the drone climb byself after loosing the connection without GPS. Hover and then try to land ist very bad....
Chris
Today I has fly my bird in some canyons and it loose first GPS and after this the connection to the controller. RTH doesn't work without GPS, so the Mavic hover and then after one minute it descend and try to land. I was lucky, the terrain war very rough and the drone stay in the air few centimeters above ground. After about 3 minutes, the GPS comes back but still no connection to the controller. RTH still doesn't work because the drone was in landing mode. After about 8 minutes I found a place to reconnect the drone, cancel the landing question "yes/no" and fly back home.
Is there any possibility by using the debug mode to change this behavior? I would like, the drone climb byself after loosing the connection without GPS. Hover and then try to land ist very bad....
Chris