Hello all,
Just picked up a Mavic Pro 2nd hand off of Facebook marketplace for a really good price. Went in knowing it had issues, so I've got most of them hammered out myself just with tinkering with it, but no research I've done for the past few days have aided me at all on this gimbal status N/A. I can fly the drone and everything acts normal, I just don't have picture on screen. It reads SD card, the front sensors are fine, etc. The only error is Camera Sensor - Send to DJI for repair. I'm thinking its the camera/gimbal board that sits on top of the gimbal, but it appears the front obstacle sensors run through that board as well and they are fine. Is partial board failure possible? I have also checked all cables and none of them have an issue.
Any ideas or further insights?
Thanks,
Brad
Just picked up a Mavic Pro 2nd hand off of Facebook marketplace for a really good price. Went in knowing it had issues, so I've got most of them hammered out myself just with tinkering with it, but no research I've done for the past few days have aided me at all on this gimbal status N/A. I can fly the drone and everything acts normal, I just don't have picture on screen. It reads SD card, the front sensors are fine, etc. The only error is Camera Sensor - Send to DJI for repair. I'm thinking its the camera/gimbal board that sits on top of the gimbal, but it appears the front obstacle sensors run through that board as well and they are fine. Is partial board failure possible? I have also checked all cables and none of them have an issue.
Any ideas or further insights?
Thanks,
Brad