Mini 2 width

[Artemis]

Can someone measure the width of the mini 2, top front half. I decided not to wrap it but have a sticker in mind that I have to custom order, and I guess the back top half too just in case… still deciding but given the current state of shipping I wanted to go ahead and order

 

[MS Coast]

Rough overall measurements from edge to edge.

Maximum width of the forward top section - 2-9/16", tapers to about 2-5/16" at the beginning of the front corner.
Maximum width of the aft top section -1-3/4", tapers to about 1-9/16" at the edge of the battery door.

Give a shout if you need anything else.

 

[Artemis]

Rough overall measurements from edge to edge.

Maximum width of the forward top section - 2-9/16", tapers to about 2-5/16" at the beginning of the front corner.
Maximum width of the aft top section -1-3/4", tapers to about 1-9/16" at the edge of the battery door.

Give a shout if you need anything else.

Thankyou… to be far more specific, this is the sticker I want, so just need to insure I don’t over size it in width…. I guess about an 1/8th inch on either side would look best

 

[Artemis]

I’m doing a SpaceX theme, my landing pad arrived today … it’s pretty cool, , a little light weight but should suffice as long as wind is ok

 

[360 Guy]

Add a backing to the pad, like cardboard or something alike.

 

[Artemis]

Looks like no dragon Sticker for my mini, print company said 4” was as low as they could go, disappointed, will have to rethink decoration plans