First off, FAA regulations are understood.
Question: From a technical perspective, could you not enhance the effectiveness of the dish-type metal, reflector, slip-on accessories by GROUNDING those metallic reflectors to the drone’s controller circuit board?
I am not a technician but It would seem to make sense with the only barriers being an external, visually acceptable and non-intrusive method of connection that does not compromise the DJI warranty.
Am I in error on the technical side of this and has anyone applied this grounding idea on any drone system?
Question: From a technical perspective, could you not enhance the effectiveness of the dish-type metal, reflector, slip-on accessories by GROUNDING those metallic reflectors to the drone’s controller circuit board?
I am not a technician but It would seem to make sense with the only barriers being an external, visually acceptable and non-intrusive method of connection that does not compromise the DJI warranty.
Am I in error on the technical side of this and has anyone applied this grounding idea on any drone system?