Topsun Strobe Question

[lilewis]

I just bought a Topsun strobe because I don't like losing VLOS, so I want to attach the strobe to the bottom of my M2P.

The strobe just arrived and I velcro'd it to the bottom between the gimbal and the downward looking sensor.

I have 2 questions before I fly with this thing stuck to the bottom:
1. If the strobe were to come off the velcro in flight, I'm assuming it would be blown downward by the propwash and not be a risk to the props. Is that correct?

2. It's very close to the downward looking sensor. Would it create any problems with the sensor's function?

I'd rather ask here before I fly instead of finding an out of control drone in the air.

 

[Tony McDrone]

If it blocks the sensor from functioning properly there will be a message on the screen. At least that how it works on the Mavic Air 2, so I might be making an assumption. Conduct your own test without a flight, you’ll still get the message if the sensor is blocked.

 

[lilewis]

If it blocks the sensor from functioning properly there will be a message on the screen. At least that how it works on the Mavic Air 2, so I might be making an assumption. Conduct your own test without a flight, you’ll still get the message if the sensor is blocked.

Thanks. Good idea. I'll do that - as soon as the recent snow is melted.

 

[Starz]

Mavic2 pro. Attached one on the front arm and one on the opposite rear arm. I’ve never had one come off during flight. As long as you’re using a good quality Velcro and making sure the two parts are seated well, they don’t come off.

 

[Mazdaman323lx]

I bought the item below just for the bracket. I attach my strobes on each of the downward facing arms where the torch should go (velcro & hot glue) with one facing forward and one facing rear. You could mount one top ring also or remove completely. Slides on to drone in seconds . Doesn't cover any of the sensors

Amazon.co.uk

 

[msinger]

The arms are a safe place to mount TOPSUN lights too: