I haven't been using my Rescue Jacket. I used it once to test it and when I was landing on the water (completely calm) the camera was going underwater.
I bought a Note 20 Ultra on Wednesday and didn't like how it fit in the controller with a case. I drew up and printed this little mount to better hold the phone. It lifts the phone up at a slight angle for easier viewing. I can post it on Thingiverse or print it for anyone who doesn't have a...
Here's a quick test I did last night dropping a water balloon from 200ft. It was a huge balloon with only a little water so it didn't even pop when it hit the ground.
I was getting it to open/close several times today by pointing the sensor towards a window without direct sunlight coming in. With the sensor holder I printed there's no need to mess with the strap or bands.
I think just extra security. Here's some pics of the stock holder and the gap along with the sensor holder I drew up and printed. You can see the little tabs with nubs on them to hold the sensor mount in place under the bracket in the last pic. I just need to put the sensor in it this evening.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.