Well I tried relinking my Cyclone antenna RC as primary and I still don't have "Center Autofocus" as an option for the C buttons, only Center Metering. Is there a way to unlink all RC's from the Mavic and then relink just the one?
Thanks,
Joe
Thanks a lot for confirming this Nozer, I will have to disconnect both RC's and only reconnect the one with the Cyclone and see if that makes a difference.
Thanks,
Joe
I had a few close calls with local birds of prey, namely a few different hawk attacks. However, since putting a red skin on my drone I haven't had a single bird show any interest in my Mavic. I went for the Bullseye skin from DecalGirl and I'm happy with it but they should make a stickier...
I still have not found a resolution to this problem and wanted to see if anybody else has come across this. Maybe it's because I have my Cyclone RC set up as a slave and the slave doesn't have access to the same settings the primary does? Or did everybody lose the ability to re-center the...
I figured I could deal with the downsides in order to benefit from this new technology, but ultimately the lag and poor OS/navigation made it impractical to rely on. Hopefully you find them more useful than I did.
-Joe
Yes, I completely shut the glasses down then restarted and was prompted to update the "System Software", aka the Android OS. If that doesn't work you could try manually updating from the system settings.
Ultimately I decided I did not like the glasses. They are a neat idea poorly implemented...
You definitely want to turn off Obstacle Avoidance when doing any type of
precision flying like this. Personally I have it off all the time as it causes more problems than it prevents for me. If you're not comfortable flying with OA off you need more practice before trying a maneuver like...
This is absolutely doable, but you might want to get a line dropping setup like they use for drone fishing. Would make dropping the line where you want without getting snagged much easier and then there's no having to shake the line loose.
-Joe
I've read from other members on here that they just ask you to write "Express" on the outside of the package separate from the address, so unless you know to ask for it I don't think it's specifically mentioned other than in the agreement. DJI CS definitely leaves a lot to be desired.
-Joe
I thought that was pretty clearly explained in the Care Refresh agreement. If you choose the Express option they automatically bill it against your Care Refresh and don't look to determine if the issue was something covered under their regular warranty, however you should get the replacement...
Until recently I've had my C1 button set to Center Autofocus. However, after adding a second RC with the Cyclone antenna system the C1 button no longer resets autofocus to the center and it's no longer an option. What happened?
Thanks,
Joe
Turn panel off, hold the small button below the screen down and while holding it turn the panel on and it will display "L3", turn the panel off then back on and the battery level should display correctly.
-Joe
I contacted Titan last night and heard back from James within 5 minutes despite it being after close of business. After charging for 24 hours the charger light was green but the panel only showed 77% battery. I went through the reset procedure and now the battery is showing 100% with a voltage...
It turns out it was shipped turned on, which I didn't realize since there's no basic instructions to be found. I assume the issue was charging with the device on, so now it's charging with the panel off. What does each position on the 3-way rocker switch indicate? I know middle is off.
I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.