Hey folks,
This is my first forum post and I think it's worth it. Firstly- I have 3 Feiyu-Tech gimbals at home so I know my way around gimbal operations.
I received my Mavic Pro 3 days ago. I updated the firmware before the first flight. I noticed after my first flight that the gimbal would only jump between the 90 and 0 degree position when using the 5D toggle on the RC. The gimbal dial on the back side of the RC does not respond AT ALL to imput commands to the gimbal tilt. Additionally, the finger slide gimbal control on the DJI control app on my iPhone 6 is "gray-ed out" but does accurately indicate the gimbal position (which jumps between only 90 and 0 degrees) although I cannot control any gimbal tilt it by that method.
The kicker is last night I attempted my first flight in Wifi mode. The
gimbal tilt control was properly functioning at all angles between 90 and 0 degrees with wifi control on my iPhone running the DJI 4 app ( using the finger slide for gimbal angle).
What am I missing? I cannot find any control settings using the RC that indicate this behavior or how to change it. Is it possible that my controller is bad since the Mavic indicated it can tilt properly under wifi control? Is there a way to reinstall firmware on the RC? Any help is much appreciated.
This is my first forum post and I think it's worth it. Firstly- I have 3 Feiyu-Tech gimbals at home so I know my way around gimbal operations.
I received my Mavic Pro 3 days ago. I updated the firmware before the first flight. I noticed after my first flight that the gimbal would only jump between the 90 and 0 degree position when using the 5D toggle on the RC. The gimbal dial on the back side of the RC does not respond AT ALL to imput commands to the gimbal tilt. Additionally, the finger slide gimbal control on the DJI control app on my iPhone 6 is "gray-ed out" but does accurately indicate the gimbal position (which jumps between only 90 and 0 degrees) although I cannot control any gimbal tilt it by that method.
The kicker is last night I attempted my first flight in Wifi mode. The
gimbal tilt control was properly functioning at all angles between 90 and 0 degrees with wifi control on my iPhone running the DJI 4 app ( using the finger slide for gimbal angle).
What am I missing? I cannot find any control settings using the RC that indicate this behavior or how to change it. Is it possible that my controller is bad since the Mavic indicated it can tilt properly under wifi control? Is there a way to reinstall firmware on the RC? Any help is much appreciated.