I know these are friction fit and AliExpress sells a tool to pull them out of the Yaw Arm.
I don't see any cracking. What do I have to observe to put it back into place?
Would a heat gun be advisable? Brass hammer? What about alignment? How are motors reinstalled if removed.
Should I coax it back in or pull/push it out to begin the reinstall?
I don't see any cracking. What do I have to observe to put it back into place?
Would a heat gun be advisable? Brass hammer? What about alignment? How are motors reinstalled if removed.
Should I coax it back in or pull/push it out to begin the reinstall?
