The flashing lights status indicator is such a relic. The information / error codes should be available on your smart app. Are you certain there are no error messages there? Did you specifically look at sensors?
The flashing lights status indicator is such a relic. The information / error codes should be available on your smart app. Are you certain there are no error messages there? Did you specifically look at sensors?
I'm using OEM bladesFlashing yellow after take off occurs with my Mavic if I fit the aftermarket carbon blades.
OEM blades do not have this effect.
I do not use the carbon blades because of this.
Its high frequency of the vibration detected by IMU on aircraft body which may be caused by proppelers.
No, it is a vibration issue. Mostly noticeable with the new quiet props. It is a non issue. DJI is aware of it.I had the same 3 yellow flashes a couple weeks ago. I recall a prior post that said to re-calibrate the compass when the 3 yellow flashes appeared. I checked the compass status screen and it indicated the compass was good. Never the less, I re-calibrated the compass and it solved the problem.
Make sure you are away from metal objects, concrete, etc that can affect the re-calibration. I once tried to take off from a picnic table and was getting compass error messages from the Go4 app. Apparently, the compass was being affected by the screws and nails holding the table together. Very sensitive to metal.
By the way, I live in the country and I'm not near any NFZ.
It has nothing to do with the VPS. It is 100% the props. They are so thin that they flex and vibrate a lot. I had the same issue on every flight with the low noise props. I put the regular props back on and have not had the yellow light issue since. I did put them back on once more to test it, and the yellow light came back. So the low noise props went into the drawer.Well I have now also experienced the 3 yellow flashes.
Not noticed yesterday when it was actually windy but today put the low noise props on and other than occasional normal green status Light mainly 3 yellow flashes.
Initially I suspected flying over snow and hence poor downward positioning perhaps?
But it never cleared even flying over clear ground.
Did a gps flight to about 1km away, flew around etc and ALL absolutely fine, no issues at all.
Searched a lot of threads and found this one mentioning vibration. Seems plausible though not gone back to standard props yet.
Anyone else ?
Its defintely vibration. Its only happened to me twice, both times i was using off brand propellors. Chaned back to dji propellors problem went away, put after market props back on, vibration thus 3 yellow lights. Change props.I have 2 mavics. One sometimes will flash yellow 3 times and repeat during flight. My other mavic flashes green. No loss of signal or anything else I can tell. Any ideas what this means?
This thread died six months ago. I think the issue has been solved. [emoji12]Its defintely vibration. Its only happened to me twice, both times i was using off brand propellors. Chaned back to dji propellors problem went away, put after market props back on, vibration thus 3 yellow lights. Change props.
Not true. I have the flash issue on a mpp that has nothing to do with props. I turned one in to DJI and they told me it had a main board problem. Sent me a refurb that did the same thing. Refurb was sold. Picked up another mpp that also does the flash. Would love to find a solution. I have given up and just “fly with the flash”.This thread died six months ago. I think the issue has been solved. [emoji12]
The three yellow flashes mean there is a vibration problem.Not true. I have the flash issue on a mpp that has nothing to do with props. I turned one in to DJI and they told me it had a main board problem. Sent me a refurb that did the same thing. Refurb was sold. Picked up another mpp that also does the flash. Would love to find a solution. I have given up and just “fly with the flash”.
Change the area you are flying in. If you have tried three different mavic and several sets of propellers, then the problem is on your end.Tried several sets of props, no difference.
We use essential cookies to make this site work, and optional cookies to enhance your experience.