Hey chazz, this is very cool. Are you working on a version2 that is a little more sleek and aerodynamic? I would pay money for one.
HEY! Are you saying it DOESN'T look like a wing!? ...
Hey chazz, this is very cool. Are you working on a version2 that is a little more sleek and aerodynamic? I would pay money for one.
It looks like a flying brickHEY! Are you saying it DOESN'T look like a wing!? ...
Lmr600 on eBay
That depends on how much loss you can sustain the LMR 600 is about 4.4 dB per 100 if I recall correctly
The LMR 400 has higher loss
I know a guy that uses 100 feet of LMR 600 with no issues and a 65 foot tower then he brings it in a building through a hole in the wall and has a room setup inside with a big tv to watch it all. He checks on his cattle every day this way.
Thanks chazz. You say when you were flying with the original motors - have you replaced them? I saw your flight out to 59000 with three protec 3600s (that's why I have 3 protec 3600s) . On that flight were you keeping your power below 80%? And were your motors warm or hot when your bird got back? I am thinking they might not get too hot while keeping your airspeed up but maybe it is more power related. But then again you had three batteries on where I only had two. Beanbubba has given me some ideas of how to keep from overheating the motors. What did mnoutdoors do with the rear covers?Hey efowler, yeah when i was flying with the original motors I pretty much did what mnoutdoors did with the rear covers and kept it under 1350 like beanbubba says and try to keep the batteries centered as much as possible and just accepted the the fact the motors are going to get warm. IDK if 5000 ft makes a noticeable difference. i'm at around 1000 and i'm ignoring the same errors your getting ... good luck man....
quick question here - do you need to run two cables one for each of the outputs of you remote??wow!!! ya I think 20-30 feet of the 400 should work fine and yes I want to get above the d*** trees..lol they are killing me! even more now with leaves
quick question here - do you need to run two cables one for each of the outputs of you remote??
Roger that - Thanksyes cause one is video image signal and the other is remote controller signal
We use essential cookies to make this site work, and optional cookies to enhance your experience.