Hi,
Hoping someone here can help me with a problem with my Mavic Pro remote controller.
Earlier today I started updating to the latest firmware (.200) on my Mavic Pro and remote controller.
Just before finishing the update, an error message popped up saying update failed.
Tried to finish the update once more, but it just stopped and displayed the error message again.
After this the remote has no symbols, numbers, letters etc on the display.
The display lights up as if it was working normally but nothing is displayed.
I tried flying with it and the controls worked fine.
When the controller is on, the power button flashes.
I don't know if it is essential, but the weather was quite cold at the time of the update.
About -1/-2 degrees celcius.
I read about something similar on here, but was hoping someone else had encountered the same thing and might have a solution.
Here's what I've tried:
1. Resetting to factory settings on both controller and drone.
2. Downgrading to FW .100
3. Upgrading and successfully installing FW .200
Thanks!
Hoping someone here can help me with a problem with my Mavic Pro remote controller.
Earlier today I started updating to the latest firmware (.200) on my Mavic Pro and remote controller.
Just before finishing the update, an error message popped up saying update failed.
Tried to finish the update once more, but it just stopped and displayed the error message again.
After this the remote has no symbols, numbers, letters etc on the display.
The display lights up as if it was working normally but nothing is displayed.
I tried flying with it and the controls worked fine.
When the controller is on, the power button flashes.
I don't know if it is essential, but the weather was quite cold at the time of the update.
About -1/-2 degrees celcius.
I read about something similar on here, but was hoping someone else had encountered the same thing and might have a solution.
Here's what I've tried:
1. Resetting to factory settings on both controller and drone.
2. Downgrading to FW .100
3. Upgrading and successfully installing FW .200
Thanks!