Vision Sensors Blocked error message.

[Mike T.]

On my almost new Air 2 (3rd flight today) I'm getting a "Vision Sensors Blocked" error message. The drone flies ok but if I get it to hover and walk up to it, I don't get any beeping that I would expect if it was sensing me as an obstruction. I Googled the term and the first thing I found was that I should clean the sensors. I did the Q-Tip and isopropyl alcohol thing on front, back and bottom sensors and that changed nothing.
I did the IMU reset this evening but didn't get a chance to re-test. I looked in the Fly menus for a on-off setting but found nothing. Does anyone have and idea what might be wrong?

 

[Rchawks]

I get that all the time on my MA2, have for years, I ignore it after takeoff and it's fine.

 

[Mike T.]

Update - after resetting the IMU last night I did a flight test this morning. There is no warning message of "Vision Sensors Blocked" and the sensors are working. I did three launches with no issues.

Follow the subtle screen changes to the letter -

What is IMU Calibration and Do I Need to do it on My Drone? | Cult of Drone

IMU calibration is a super important part of owning a drone. If you don't calibrate it, you may not be able to fly your drone or you could end up crashing it. In today's post, we'll be going through everything you need to know about IMU calibration. From what it…

cultofdrone.com