Gimbal and camera not working after crash

[BarteXtreme]

Hey there.
So in December while filming in a city between buildings my Mavic Pro disconnected from the controller and hit a lamp post. Today I finally got around to try flying it. In spite of all the plastics being broken it flies fine.
However the gimbal and camera are not working. After I turn on the drone the gimbal doesn't move, the preview on my phone is black and it says "gimbal overloaded".
What do you recon do I have to replace? The whole gimbal or is there another option?
I'll be grateful for any help since this is my first drone(I don't know much about it) and I need it for a few shootings next week

 

[Former Member]

I would start with the ribbon cable.

Watch out for this one:

If you are repairing your gimbal, be careful with this cable.

 

[BarteXtreme]

Can I trust any aftermarket ones or OEM only?

 

[Former Member]

Can I trust any aftermarket ones or OEM only?

If you buy aftermarket ones, buy a few just in case one doesnt work.

 

[BarteXtreme]

Ok, thanks. I'll do that and update after I've done it

 

[BarteXtreme]

I would start with the ribbon cable.

Watch out for this one:

If you are repairing your gimbal, be careful with this cable.

Thanks for the tip. It saved me some money. I changed both the ribbon and LVDS cable and everything works!
I broke one of those rubber bands on the vibration plate but managed to connect it with a zip tie Where can I find one of them and how difficult is it to replace it?