Help to exchange rear landing gear Mavic 2

[Constancio da Silveira]

If anyone can help me remove the damaged parts and put in the new ones. I do not know if it needs to open or if I can make the change outside to not cause any damage.
thanks

 

[TampaTC]

So by the photos of the replacement parts it looks as tho you have to take the aircraft apart. Looks as tho the parts push thru.
What happen to the original ones?

 

[wildlifr]

Just unscrew and remove the bottom cover. It's just a couple screws and then a ribbon cable on the micro sd card side (I think).
Mavic 2 teardown

 

[Constancio da Silveira]

So by the photos of the replacement parts it looks as tho you have to take the aircraft apart. Looks as tho the parts push thru.
What happen to the original ones?

The original opened a small fissure and I'm afraid to break when it lands.

 

[TTP]

I lost one of mine, lock like is just push in to the body of the drone, cannot see any screws.

I wonder, where did you get the spar parts, I have tried to find then at DJI, but no.

 

[Constancio da Silveira]

I lost one of mine, lock like is just push in to the body of the drone, cannot see any screws.

I wonder, where did you get the spar parts, I have tried to find then at DJI, but no.

I found it on amazon.

 

[TTP]

Tanks!

 

[DanMan32]

Probably fairly easy to install without opening, but probably not to remove. If the installed one is damaged, looks like you could find a way to break it off completely without damaging the body.

 

[TTP]

Did you just push the landing gear in place or did you have to remove the bottom cover first?

 

[TTP]

When I sent my M2P to DJI service for repair, (I had crashed an engine)
I asked them to put a new rear landing gear, but they changed the whole bottom plate of the drone,
about 20 US $, so it was obviously something not so easily,
the mounting of the rear landing gear apparently occurs when the drone is assembled during manufacture.