Mavic Pro 2

[gleymarc]

Just purchased a Mavic Pro 2 and I cannot get the aircraft to start. Have 3 fully charged batteries. I press the button twice as directed. The second time, the light comes on for a few seconds and goes out. What am I doing wrong?

 

[Viper X96]

Hi. Not sure if the same on Mavic 2 as older model but with that one its one quick press then press and hold on the power button until lights on drone are lit.

 

[gleymarc]

Hi. Not sure if the same on Mavic 2 as older model but with that one its one quick press then press and hold on the power button until lights on drone are lit.

Done that, does not work.

 

[Viper X96]

Not sure then on that one. Hopefully it is something simple and one of the MP2 owners will put you right. If not then a return to supplier maybe needed.

 

[gleymarc]

Thanks, I might also be on the edge of a no fly zone.

 

[old man mavic]

take the battery out of the drone and give a quick press and then press and hold, you have to do it straight away after the first press and keep the button down till all the lights come on, if you do it out of the drone it wont matter if it is a no fly zone or not it, just takes a little practice to get the timing right good luck

 

[charlas]

Yup should just be a press-lift-press and hold, the lights will light in turn all the way around till all 4 lit, then it should tritch its props and do its beep.

 

[Ken K]

Yup should just be a press-lift-press and hold, the lights will light in turn all the way around till all 4 lit, then it should tritch its props and do its beep.

And don't forget to remove the gimbal guard before you start up so that the gimbal can perform it's dance unimpeded.