I have an M2P that I just replaced a signal cable and Pitch motor for a client. He crashed it and had to buy it. I tried to op check it. No error codes. Motors all spun up. I applied up stick, i heard the motor RPM increase very slightly but it will not spin up to fly. Not in a restricted zone. All updates seem to be current. I suspect the ESC board is shot. Does anyone have any suggestions on how I should proceed?
Edit: After getting back into the drone and just going through every setting possible, I discovered the remote was in mode 3 which puts the up/down on the right stick. First time ever I have encountered someone in the US not using mode 2.
So have a laugh at me and let this be a lesson to people who fix drones.
Edit: After getting back into the drone and just going through every setting possible, I discovered the remote was in mode 3 which puts the up/down on the right stick. First time ever I have encountered someone in the US not using mode 2.
So have a laugh at me and let this be a lesson to people who fix drones.
Last edited:
