Well,
For some reason the drone didn't stop while I was accidentally flying it towards my house wall
Usually it stops if an obstacle is sensored but this time it didn't so I "kissed" the wall and fell into my flower pot, and I found it with the tip ripped off. See the pic. I am planning to firstly try to apply some glue and see if it works out that way. Will I be able to deal with the 3 wires soldering them back to the motor? What type of glue should I look for specifically?
What are your thoughts about it? Worth trying in my case? I do not have the refresh insurance and before sending it back to Netherlands for an expensive repair I would like to give it a try. Why not? Please throw with pros and cons in me. I appreciate you getting time reading this. Cheers.
For some reason the drone didn't stop while I was accidentally flying it towards my house wall
Usually it stops if an obstacle is sensored but this time it didn't so I "kissed" the wall and fell into my flower pot, and I found it with the tip ripped off. See the pic. I am planning to firstly try to apply some glue and see if it works out that way. Will I be able to deal with the 3 wires soldering them back to the motor? What type of glue should I look for specifically?
What are your thoughts about it? Worth trying in my case? I do not have the refresh insurance and before sending it back to Netherlands for an expensive repair I would like to give it a try. Why not? Please throw with pros and cons in me. I appreciate you getting time reading this. Cheers.