Fitted rotor cover for M2P that does not touch the spindle (shaft)

[lomposlapos]

There are several covers out there.
I can not find one whose inside does not come into contact with the spindle. So during transport, instead of resting on the spindle, the M2P rests on the spindle cover.

 

[johnmeyer]

I'm not sure why you don't want the cover to touch the spindle. Here are the ones I 3D printed for my M2Pro:

Mavic 2 Motor Cover

The cover goes over the outside of the motor mount, instead of fastening to the inside, in the same way the props are fastened. By going on the outside and covering the spindle, they provide complete lateral support for the spindle. Many of the other covers I looked at leave the spindle exposed and I was very concerned that, during transport, one or more of the spindles could be bumped or pressured laterally, resulting in a bent pin.

In this design, all the lateral pressure is transferred to the outside of the motor mount, something that is much sturdier than the spindles.

These covers also provide complete protection from dust and debris getting down into the motors or coils.

I think there are commercial versions of roughly this same design.