Prevent gimbal overload caused by not removing the cover at power up

[B-kane]

As a noobie I constantly forget to remove the gimbal cover before powering up.a simple mod I have done to prevent this is to cut and hot glue a piece of plastic sheet to the cover. Now when I power up the mod reminds me to remove the cover thus preventing gimbal overload. I will probably paint it red as an extra precaution.

 

[PedroHN]

Everyone makes this mistake and DJI does not mind putting a warning on it.

 

[ATP]

Add a “Remove before flight” label too.

 

[B-kane]

Watched a YouTube video showing how to cure the critical error on the gimbal but all it shows is recalibration. The led,s still show red even though the gimbal appears to work normally.