repair

In an act of pure genius, I backed my Mavic into a tree two weeks ago, luckily nobody was injured as it made its way indelicately to the ground. Despite falling through a tree from around 100 ft, the only permanent damage was a snapped rear motor arm. I was able to purchase the motor arm...

Ok, it happened; I crashed my Mavic and had it repaired by DJI on the left-coast. After 3 weeks, the Mavic arrived. I first had problems connecting the RC. No connection so I reloaded the DJI Go 4 Android app. Had to go through the initial stuff including the Firmware. Now it's connecting. Next...

I just received my Mavic Pro, coming from a salvaged Parrot Bebop that had suffered water damage and I had to replace the motherboard. It served me well but I'm glad I get to retire it. I have 24 hours left to aquire the DJI Care Refresh and I've been going through Mavic Pros' crash videos...

Hi I need a left landing leg and the PCB or PCB and cable for the black aerial Will it be easier to source and replace the leg and aerial or whole arm The leg is missing so I can't repair it and the cable has pulled the pads off the PCB If anyone is going to offer parts I also could do with a...

So, like a moron, I was playing around in sport mode and managed to clip a tree. Now my front right arm has broken plastic at the hinge. I've seen arms being sold on ebay, but I'm very hesitant to purchase one and attempt the repair myself. Any advice would be well taken. Thanks

Hey guys, so after a crash my front right arm is loose. Took off the cover to see what was wrong and the part highlighted below was not sitting flush, it is pushed up with significant pressure, and after several failed attempts to put it back the way it should be, I'm at a loss as to what I...

Flew low over a salt water river the other day and am concerned I got some spray in the drone. I took the bottom cover off and this is what I saw: IMG_5005 by Dunial posted Aug 13, 2017 at 2:30 PM Does anyone have a photo of there motherboard? Is this normal?

So, I've had my Mavic broken for a while now, and I've finally decided to bite the bullet and get it repaired, since its just a $1300 paperweight at the moment. I'm aware that DJI repair is an expensive and slow option, and that ThunderDrones will typically be able to fix it faster and cheaper...

I purchased my bird in early march (w DJI refresh) and crashed it in early May. Sent it in for repair early June under the program and got it back July 10 (yesterday). This bird has a different serial number so I assume t hat they replaced mine with another one. When I booted everything up...

So I replaced both the silver wire and the ribbon cable to my mavic gimbal after I had a bird drop my Mavic from about 150' up. After replacing the ribbon cable the mavic gimbal moved fine but I wasn't receiving any video transmission. I then replaced the silver wires to the camera and now I can...

last week, while doing a pullaway shot, crashed my mavic into woods. didn't find it at that time. today, went back to the location, found it lying on the ground with some dirt, broken blades etc.. I took it home, cleaned, battery charged. it took off, but it wasn't hovering at 3ft but It was...

Does anyone know the proper solder used on the Mavic? I'm replacing a rear arm. I have read here that the solder joints require high heat, so I'm assuming the solder is lead free. I don't know anything about this type of solder, so I'm not sure what to get. Alloy, temp, diameter, etc. Any...

I opened a case with DJI Support because my Mavic cooling fan stopped working and I began receiving a warning of "aircraft core board overheated". I just received the assesment and repair invoice for replacing a gimbal mounting bracket, both rear motor arms, a couple of shell components and a...

Hi guys, Long story short, overconfidence led me to attempt to land on an industrial digger's cabin roof ... rotorwash, Maddie slipped off, cracking her eyeball into the light cluster on her way down. Damage? Gimbal arm mount snapped, gimbal arm motor ribbon cable snapped ... camera ended up...

Hi all, Needing some serious help! SILVER GIMBAL CABLE HAS SNAPPED My friend bought a new DJI Mavic Pro in South Africa. When we were traveling Europe he crashed it from quite a height and felt that he didn't want to (couldn't be bothered) to repair/replace it, The damage that is sustained...

I guess I may be the first to damage my remote control because I cannot find any other posting similar to the help I need. Unfortunately, following a flight last week, I dropped my remote. I didn't think anything of it until the next time I tried to fly and the remote was not connecting to my...

I had my mavic repaired at the DJI repair facility here in California. In the box that I shipped, I had the damaged drone, propellers, damaged gimbal, and the remote control. I received the Mavic today (March 20th 2017) in the mail, but the remote control was note in the package that was sent...

Hi, Today my Mavic crashed from 30-40 m on the concrete steps. It happened after 1 min after took off. I tried to get some height, near the building. When it reached ~30 meters, it said that "maximum altitude reached", but I set it to 100 meters then Mavic drifted backwards and crashed into the...

Hi all, I send my Mavic to DJI's repair center for some repairs. According to their instructions I sent the remote and Aircraft with out the battery and propellers. My concern is, I forgot to remove the RC USB Cable from the remote. Does anyone have any experience in this, I am now wondering if...

Has anyone had a quote for replacing the Camera & Gimbal from Drone doctors in the uk (DJI recommended service centre here) I just got one but want to see if anyone else has had one and compare before I go ahead with the repair